Skip to content

Parameters

pd sc cwl tof neut xray

Choose independent parameters

On Analysis → Main, use the table filters to find a parameter. Edit its value and use the free checkbox to choose whether it may vary. The checkbox is disabled when a fit cannot vary the value, because it describes the setup, symmetry or a constraint sets it, the fit's data cannot determine it, or the calculation has no derivative for it yet. Hover over it to see which.

The displayed minimum and maximum describe admissible model values. See parameters and fit a pattern.

Inspect the analysis view here. Its content changes with the active page and selection.

Main workspace

Use the enabled Main, Extra, Text and Settings tabs to inspect and edit this page.

Sidebar

Read project counts, messages, calculation and fitting state here.

Status bar